A single rigid panel that pivots up and back: the simplest mechanism, the cleanest face, and the best base for fully custom and flush-clad designs.

Two reasons: unusual openings and uninterrupted design. Because a tilt door is one panel, there are no horizontal joins to interrupt cladding, which is why most premium flush-mount doors are built on tilt hardware. The mechanism is simple and robust, and it copes with openings that are too low, wide or irregular for sectional tracks.
One uninterrupted face takes cedar, batten and panel cladding beautifully, see flush mount doors.
Low headroom, wide spans and non-standard shapes that sectional tracks cannot handle.
Fewer moving parts than any other door type: pivots, springs, done.
A tilt panel sweeps outward and occupies part of the ceiling zone when open. If you need to park hard against the door or keep the ceiling free, compare with a sectional door at your measure.

A tilt door suits older Auckland garages with a narrow opening, a timber or custom face, and enough driveway for the leaf to swing out as it lifts. A sectional door suits attached garages that need insulation. A roller door suits sheds and tight headroom. All three can run on a remote, so operation is rarely the deciding factor.
Compare every option across the full garage door range.
Ideal for custom cladding and non-standard openings, we will confirm fit at the measure.
021 764 609