Corrugated steel curtains that coil into a compact drum: the practical choice for tight headroom, carports, sheds and rentals, in any NZ steel colour.

When space is the constraint. A roller door needs no ceiling tracks and minimal side room: the curtain coils into a drum above the opening: so it suits garages with high stud storage, carports, sheds and workshops. For attached garages where warmth and quiet matter more, a sectional door (which takes insulation) is usually the better pick; we will tell you straight which suits your garage.
No ceiling tracks, your garage roof stays free for storage racks or a kayak. The drum does need clear headroom above the opening, which we measure on site.
Cost-effective, tough and low-maintenance: the workhorse choice for investment properties, baches and sheds.
Shopfront and industrial roller shutters for cafés, workshops and storage units, ask about commercial specs.
The Merlin SilentDrive Elite automates any of our roller doors, with optional battery backup and auto-lock. See roller door openers →

For a detached garage, a shed or a carport where headroom is tight, a roller door is usually the better buy: it costs less, needs no ceiling space, and the curtain coils into a compact drum above the opening. For an attached garage you heat or use as a room, a sectional door wins, because only a panel door carries worthwhile insulation.
A roller door uses no ceiling space at all, so storage racks, a mezzanine or a bike hoist stay usable. A sectional door runs on horizontal tracks under the ceiling, which takes that ceiling space but leaves the wall above the opening clear.
A sectional door accepts insulated panels, so it is the only real choice where energy efficiency matters. A roller curtain carries no meaningful insulation option, and a single skin of steel passes more road noise than a foam-cored panel does.
Roller doors are the cheapest way to close an opening and have fewer moving parts to wear. Sectional doors cost more up front and give you more profiles, finishes and colours in return.
Timber, glass and architectural doors cost more again. Replacing a door on an existing opening is cheaper than a new build, because the opening is already framed.
Every roller door is made to your measured opening rather than cut down from a stock size. We measure the opening, the available headroom and the side room, confirm the drum size and curtain drop, then order the door in your chosen steel colour. Garage door installation on an existing opening is usually a single visit.
We check the opening width and height, the headroom the drum needs and the side room for the guides. Out-of-square openings and timber lintels get noted here, because they change the fix.
The curtain is rolled to your measurements in NZ steel and finished in a New Zealand steel colour. Guides, drum, barrel and spring are matched to the finished curtain weight as one garage door system.
Old door and hardware out, guides plumbed, curtain hung, spring tensioned and the travel set. Automated doors are paired to the opener and the safety reverse tested before we hand it over.
Roller doors are low maintenance, not no maintenance. Wash the curtain down a few times a year, more often near the coast, and keep the guides clear of grit. The parts that show wear and tear first are the spring, the bottom seal and the guides. We handle garage door repair on any brand of roller door, not only the ones we supplied.
Customer service after the sale is the part people remember, so the person who quotes your door is the person you call if something needs attention. See garage door repairs for callouts on an existing door.
Measured and quoted at your place: house, bach, shed or shopfront.
021 764 609